Availability: | |
---|---|
BL-M8715QT4
LB-LINK
Without BT
REALTEK
1T1R
IoT:UART,I2C,SPI,GPIO
Introduction
The BL-M8715QT4 is a Highly integrated ultra-low power IP camera module base on RTL8715AQD, which combines ARM v8M CPU, Memory unit, Security unit, Power management unit, Video unit, Audio unit, WLAN unit in a single chip. It provides rich functional interfaces such as analog audio, MIPI video, USB 2.0 host or device, SDMMC HS or SDIO device, RMII, it also provides a bunch of configurable GPIOs which are configured as digital peripherals, ADC inputs, PWM outputs. With so many advantages, BL-M8715QT4 ideal for multi-function, small size and cost-effective high-definition IP cameras!
Features
Video
Support MIPI CSI-2 two data lane interface CMOS sensor
Integrated image signal processor supports multiple and professional image processing functions
Support digital image stabilization(720p)
Support motion detection and private mask
Integrated Encoder supports Max 2megapixel resolution for H.264 encding with multiple profiles and levels
Support multiple stream real-time H.264/JPEG JPEG encoding outputs with individual scaling down size
Support Constant Bit Rate/Variable Bit Rate control
Audio
Integrated Audio Codec with 16 bit DAC and ADC, 5band configurable EQ supported
Support Mono Speaker output with 16Ω and 32Ω loading
Support Mono Microphone input with build-in Mic bias generator
CPU and Memory
ARM v8M MCU with 300MHz clock and 2.23 DMIPS/MHz
Embedded 32MB LPDDR1 memory up to 200MHz
Support external (on customer's mainboard, 1.8V I/O ) SPI/QPI NOR Flash
WLAN
Operating Frequencies: 2.4~2.4835&5.15~5.85GHz
Compatible IEEE 802.11b/g/n/ac 1T1R WLAN PHY rate up to 150Mbps
High speed interface
USB 2.0 host HS/FS or USB 2.0 device HS/FS selectable
SDMMC 3.0 with DDR-50/SDR-50 mode or SDIO device 2.0 with SDR25 supported
IEEE 802.3/u compliant RMII interface can support both PYH/MAC mode
Peripheral interfaces
Support 5 UART with multiple selectable interfaces, max baud rate 4MHz
Support I2S and PCM with multiple selectable interfaces
MAX 4 I2C with 3-speeds, either master or slave mode supported
MAX 2 SPI interfaces with master or slave mode supported
MAX 3 ADC with 10-bit mode and 32KHz sample rate
Block Diagram
General Specifications
Module Name | BL-M8715QT4 Camera Module |
Chipset | RTL8715AQD-VR3-CG |
WLAN Standards | IEEE802.11b/g/n/ac, 1T1R 150Mbps (Max) |
Bus Protocol | NOR Flash/SPI/USB2.0 /Audio/UART/MIPI/ISP/I2C/I2S/SDMMC/MII/PCM |
Antenna | Connect to external antenna through IPEX-4 connector |
Dimension | SMD 68Pins, 17.6*16.5*1.8mm (L*W*H) |
Power Supply | DC 3.3V±0.2V @ 500 mA (Max) |
Operation Temperature | -20℃ to +85℃ |
Operation Humidity | 10% to 95% RH (Non-Condensing) |
Product Dimension
Module dimension: 17.6*16.5*1.8mm (L*W*H; Tolerance: ±0.3mm_L/W, ±0.2mm_H)
IPEX / MHF-4 connector dimension: 2.0*2.0*0.6mm (L*W*H, Ø1.5mm)
Package specification:
1. 1,000 modules per roll and 5,000 modules per box.
2. Outer box size: 37.5*36*29cm.
3. The diameter of the blue environment-friendly rubber plate is 13 inches, with a total thickness of 36mm
(with a width of 32mm carrying belt).
4. Put 1 package of dry agent (20g) and 1 humidity card in each anti-static vacuum bag.
5. Each carton is packed with 5 boxes.
Introduction
The BL-M8715QT4 is a Highly integrated ultra-low power IP camera module base on RTL8715AQD, which combines ARM v8M CPU, Memory unit, Security unit, Power management unit, Video unit, Audio unit, WLAN unit in a single chip. It provides rich functional interfaces such as analog audio, MIPI video, USB 2.0 host or device, SDMMC HS or SDIO device, RMII, it also provides a bunch of configurable GPIOs which are configured as digital peripherals, ADC inputs, PWM outputs. With so many advantages, BL-M8715QT4 ideal for multi-function, small size and cost-effective high-definition IP cameras!
Features
Video
Support MIPI CSI-2 two data lane interface CMOS sensor
Integrated image signal processor supports multiple and professional image processing functions
Support digital image stabilization(720p)
Support motion detection and private mask
Integrated Encoder supports Max 2megapixel resolution for H.264 encding with multiple profiles and levels
Support multiple stream real-time H.264/JPEG JPEG encoding outputs with individual scaling down size
Support Constant Bit Rate/Variable Bit Rate control
Audio
Integrated Audio Codec with 16 bit DAC and ADC, 5band configurable EQ supported
Support Mono Speaker output with 16Ω and 32Ω loading
Support Mono Microphone input with build-in Mic bias generator
CPU and Memory
ARM v8M MCU with 300MHz clock and 2.23 DMIPS/MHz
Embedded 32MB LPDDR1 memory up to 200MHz
Support external (on customer's mainboard, 1.8V I/O ) SPI/QPI NOR Flash
WLAN
Operating Frequencies: 2.4~2.4835&5.15~5.85GHz
Compatible IEEE 802.11b/g/n/ac 1T1R WLAN PHY rate up to 150Mbps
High speed interface
USB 2.0 host HS/FS or USB 2.0 device HS/FS selectable
SDMMC 3.0 with DDR-50/SDR-50 mode or SDIO device 2.0 with SDR25 supported
IEEE 802.3/u compliant RMII interface can support both PYH/MAC mode
Peripheral interfaces
Support 5 UART with multiple selectable interfaces, max baud rate 4MHz
Support I2S and PCM with multiple selectable interfaces
MAX 4 I2C with 3-speeds, either master or slave mode supported
MAX 2 SPI interfaces with master or slave mode supported
MAX 3 ADC with 10-bit mode and 32KHz sample rate
Block Diagram
General Specifications
Module Name | BL-M8715QT4 Camera Module |
Chipset | RTL8715AQD-VR3-CG |
WLAN Standards | IEEE802.11b/g/n/ac, 1T1R 150Mbps (Max) |
Bus Protocol | NOR Flash/SPI/USB2.0 /Audio/UART/MIPI/ISP/I2C/I2S/SDMMC/MII/PCM |
Antenna | Connect to external antenna through IPEX-4 connector |
Dimension | SMD 68Pins, 17.6*16.5*1.8mm (L*W*H) |
Power Supply | DC 3.3V±0.2V @ 500 mA (Max) |
Operation Temperature | -20℃ to +85℃ |
Operation Humidity | 10% to 95% RH (Non-Condensing) |
Product Dimension
Module dimension: 17.6*16.5*1.8mm (L*W*H; Tolerance: ±0.3mm_L/W, ±0.2mm_H)
IPEX / MHF-4 connector dimension: 2.0*2.0*0.6mm (L*W*H, Ø1.5mm)
Package specification:
1. 1,000 modules per roll and 5,000 modules per box.
2. Outer box size: 37.5*36*29cm.
3. The diameter of the blue environment-friendly rubber plate is 13 inches, with a total thickness of 36mm
(with a width of 32mm carrying belt).
4. Put 1 package of dry agent (20g) and 1 humidity card in each anti-static vacuum bag.
5. Each carton is packed with 5 boxes.
content is empty!